Saturday, September 21, 2013

Five minute jogging stroller rain shield

I’m really hoping Friday marked the beginning of a nice, rainy fall. I love rain, but hate driving to pick Finn up from school. The car line is almost impossible to deal with, so I always park nearby and walk up. With the time it takes to get Beckett in and out of the car at home and at the school, finding a place to park and then fighting the traffic to get in and out, I’m almost positive walking is quicker. It’s certainly more pleasant. So, I decided to make a rain cover for the stroller. I don’t mind a little rain, but Beckett hates it. Weirdo.

I went the incredibly quick, made with stuff on hand route. I may upgrade it in the future, but for now I’m sure it will do. First, I took some clear vinyl material that has been sitting in my stash for years now and draped it over the stroller where I wanted it and trimmed of the excess length. Then I measured the sides from the edge of the vinyl to the frame of the stroller (14 inches for each side in my case). That part I planned to do in some sort of breathable fabric.

IMG_4530

To attach it to the frame, I planned to use elastic around the edge. That idea came one day last week when I thought I might have to walk in the rain and discovered that a fitted crib sheet almost fit perfectly in place over the stroller. I have some thrifted sheets, so I found a fitted twin and cut the 14 inches off ends with the elastic. I used the serger to attach the cut sides of the sheet to the long sides of the vinyl. (Note to self: vinyl goes on TOP near the foot, not on bottom.) Once I figured out proper material placement, constructing it took maybe three minutes.

It’s still not snuggly fitted, but with a couple of binder clips to tighten the top edge it would have worked for Friday if I hadn’t chickened out due to the possibility of thunderstorms. Rain I can handle, but dodging lightening is a bit much. I will probably add a few darts or snaps to snug it up some if I think it will be used a lot.